I have an industrial project where there will be one master controller connected to six (6) slave controllers. The physical location of the plant is such that it would be very much feasible for me to ...

I have some question s on the fueses. this is not only relates to TPS2HCS10-Q1, but in generakl for the HCS -Family. I have following questions: Standby - Active Mode of MCU eFuses must be active even ...

2)VIO pin required & supply voltage level is 3.3v 3)Should have CAN Signal improvement capability as per CiA-601-4 standard I am seeing the potential of TCAN1042-Q1. Will this work with the ...

This is due to the internal 100k pull-up resistors that cannot be disabled within the IO expander. This is why there is a difference between HIGH and LOW inputs. LOW inputs will cause current to flow ...

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

We are seeking assistance with a Flyback SMPS design using the UCC28750 controller. The design was based on the UCC28750EVM-071 User Guide and the UCC28750 Datasheet. At no load, the output reaches a ...

Vin: I created a circuit that boots from 5V to 6.3V and converts it to 5V with a regulator, but when I connect a 100mA load, Vout drops to 5.3V. Can you catch a waveform of the unexpected Vout drop.

We are facing an issue during training a model (Yolox_s_lite) that has 7400 images for object detection in EdgeAi Studio. The following error message are appearing in ...

That model doesn't contain POP trigger on schematic. If using STEADY_STATE model, make sure you have the settings for model set like this: You can get the needed setting and bode tools from other ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...